Cement and concrete splatters from construction sites and other projects can seem a bit daunting to get off without scratching the paint. However, there are a few ways you can quickly click here and inexpensively remove cement stains yourself.
Part one:
Dissolving cement stains first Start by blocking the area around the cement stain with tape. Place 4-5 pieces of painter’s tape on each side of the stain. This will help provide you with a safety net to avoid spills. If you spray cleaner on an undamaged part of your car, chances are you’re accidentally damaging the paintwork of your car.
- You will need to use a special cement remover on the stain for an easy fix. You can purchase one of these cementitious solutions at your local hardware store or online. These solutions are often environmentally safe acidic alternatives with an active ingredient found naturally in sugarcane syrup.
- Spray cement stains with vinegar if you’re looking for a much more affordable solution. Pour pure white vinegar halfway into a spray bottle and pour warm water over it. Shake the spray bottle for at least 5 minutes to fully combine the water and vinegar. The acidity of the vinegar will help break up your cement stains, making them easier to remove. A jar of cement remover on the market can easily cost you more than $20, but you can buy a full jar of vinegar for less than $10.
- Spray the solution directly onto the stain to remove the stain. It helps if you wet all of the cement with water and vinegar or a commercial cement remover. Let the solution sit for a few minutes, then spray again to soften the stain. Soak the affected area with plenty of solution as long as you have a bandage around it.
Part 2
Clean the cement stains on the car first It helps to start by using a kitchen spoon covered with a cloth to scrape off the cement. Try using a wooden or plastic spoon, not metal. Gently scrape and peel off the cement to remove the loose concrete from the surface of your vehicle. You need to dig the spoon properly under the stain and stir until the concrete loosens and eventually falls. You must cover your spatula with a cloth as this can also damage your car’s paint if it rubs against the car on its own.
- It’s best to start by pressing cloth over the stain after spraying a little more solution. Once you have removed all the large cement from the surface of the car, it is time to gradually lift the thin cement layer. Hold your cloth over the stain for a few minutes to dissolve any remaining cement. Repeat the same spraying and pressing process until you have removed most of the cement from the vehicle. Remember that you shouldn’t rub the cloth over the stain as this can damage the car’s paintwork and make the stain nearly impossible to remove.
- Use a clay bar to remove the last particles of cement. Start by adding a little water to the yellowed skin or lubricant before using the clay stick. Apply the material to the top coat in a slow and gentle circular motion to remove small debris. You can purchase a clay bar at your local hardware store, garage, or home improvement store.
- It is best to shave the affected area after the pimple is removed. Start by placing a thumb-sized car wax ball on any lint-free cloth and rub the wax into the paint in small, circular motions. Try using rows of circles either vertically or horizontally and cover the entire affected surface of the vehicle while making sure to apply a thin layer of wax.